To determine if the right rear fog light is broken, you can visually inspect the light to see if it is cracked, damaged, or not functioning. You can also turn on the fog lights and check if the right rear fog light is illuminated. If the light does not turn on or appears to be damaged, then it is likely broken and may need to be replaced or repaired. Additionally, you can consult the vehicle's manual for guidance on troubleshooting and replacing the fog light. **

To connect the Speedfight MTKT tail with rear light and the STR8 rear light with blink function, you will need to identify the wiring connections for both lights. Once you have identified the wiring, you can use compatible connectors or soldering to join the wires from the Speedfight MTKT tail light to the STR8 rear light. Make sure to match the positive and negative connections correctly to avoid any electrical issues. Additionally, you may need to install a separate blinker relay or resistor to ensure the blink function works properly with the new setup. Always refer to the wiring diagrams and instructions provided with the lights for proper installation. **

The legality of a moped tail light depends on whether it meets the specific requirements set by the local transportation authorities. In most places, moped tail lights must be a certain color, brightness, and positioned at a specific height from the ground. It is important to check the local regulations and ensure that the moped tail light complies with the law to avoid any legal issues. **

Without more context or a specific image, it is difficult to determine if the light in question is a rear fog light. Rear fog lights are typically located at the rear of the vehicle and are used in low visibility conditions to increase the vehicle's visibility to other drivers. They are usually a bright red color and are often located near the lower part of the rear bumper. If the light in question meets these criteria, it is likely a rear fog light. **

There is no definitive answer to whether it is safer to sit in the rear right or rear left of a car as safety can depend on various factors. However, statistically, the rear right seat is considered slightly safer in some countries due to the direction of traffic flow. It is important to always wear a seatbelt and ensure that all passengers are properly restrained, regardless of where they are seated in the car. **

The right rear wheel is being blocked by a large rock that is wedged underneath it. This rock is preventing the wheel from moving freely and is causing the vehicle to be stuck in its current position. In order to move the vehicle, the rock will need to be removed from underneath the wheel. **

To repair a bicycle tail light, start by checking the batteries or power source to ensure it is working properly. If the issue is with the bulb, replace it with a new one of the same type. Make sure all connections are secure and free of any corrosion or damage. If the problem persists, consider taking the tail light to a bike shop for professional repair or replacement. **

The bicycle tail light may not be working due to a few possible reasons. It could be a simple issue such as a dead battery or a loose connection. Alternatively, the light bulb or LED may have burned out and needs to be replaced. It's also possible that there is a problem with the wiring or the switch. Checking these components and troubleshooting the issue should help determine the cause of the malfunction. **